<center id="6qa8s"><div id="6qa8s"></div></center>
<noscript id="6qa8s"></noscript>
<center id="6qa8s"><wbr id="6qa8s"></wbr></center>
<optgroup id="6qa8s"><wbr id="6qa8s"></wbr></optgroup><center id="6qa8s"></center>
<center id="6qa8s"><div id="6qa8s"></div></center>
<center id="6qa8s"></center>
<optgroup id="6qa8s"></optgroup>

Maintenance Of Induction Bending Machine 返回首頁

1. When cleaning the induction bending machine, clean the inlet filter of each pump.

2. Clean the fuel tank and filter the hydraulic tank within 1-2 months after the equipment is used.

3. If it is found that the forward and retreat is unsuccessful, first check whether the solenoid valve is working, such as the solenoid valve is working normally, and then check whether the sequence valve 6X3, the relief valve YF-L20H4 or the one-way unloading valve 4HD3 is stuck with impurities. (This phenomenon is usually easy to happen when the device starts to use). If there is a stuck phenomenon, after disassembling it with gasoline or diesel, reinstall it.

4. Each joint of the hydraulic pump station is equipped with oil-resistant rubber sealing ring. If the sealing ring is damaged or leaking, it should be replaced in time.

5. Check the fasteners in each part of high quality induction bending machine to make them tight.

induction bending machine

上一篇:Troubleshooting Of High Quality Induction Bending Machine

下一篇:Advantages and disadvantages of hot and cold bending

TEL:0086-139-31703233
Fax : 0086-317-6817833
Email:lmdzjxc@lmdzjxc.com
Address:Xiwang New District ,Mengcun Hui Autonomous County, Hebei province,China. sitemap google

Facebook Linkedin Pinterest 冀ICP備12017094號-2
观看亚洲色欲色欲色欲www